...line F7 is the code for a stuck function switch or bad keypad. Makes sense that it's telling you to start the lower oven. Try removing the ribbon cable from the board and cleaning the ends with an ...
ground or went bad, going to try tomorrow and let you know, the on line tech charge is 29 dollars. maybe I ca help someone out there that can save a few bucks.probe jack is accessible from inside oven
...bad oven temperature probe. It will be mounted on the back of the oven wall (usually in the upper right or upper left corner). To check the probe, unplug the range and remove the back panel. There ...
Question about 62622 Microwave Oven
...line for a few minutes, plug it back in, set the clock, then try again. If that doesn't work, please reply back with your exact model number. A full Sears/Kenmore model number usually has 3 digits, a ...
Question about JBP24 QuickClean Electric Kitchen Range
GE JBP66 Self Cleaning Radiant Range On the display BAD LINE flashes with beeping and oven shuts off if it is on Your range is wired improperly. Hot wires go on the two outside terminals.
bad line. I started making sure I didnt disconnect any plugs and the first one I checked popped. It was the first one from right when looking from the front of the stove. It is on where the time shows
Question about RGB745 Gas Kitchen Range
bad line and beeps steady put a plug on it that has ground. "bad line" error means the control panel is not seeing a proper voltage to the oven. Have the power connections checked with a voltmeter all
...that the EEPROM (Electrically Erasable Programmable Read-Only Memory) on the control board is bad. This can be caused by a power surge or glitch through the electrical lines. You can try to ...
Question about RB757 Electric Kitchen Range
Bad Line" flashing on the screen. Turning off the circuit is the only way to stop the beep. I replaced the cord on the range and not change in problem. The outlet still has power to it, I checked that
Question about RB757 Electric Kitchen Range
line reading was correct. It still beeps. Got E21 and replaced the UIB and the controller. Thought it was all OK but after an hour of the stovetop working, it went back to E31. What's going on? I need
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions