...jammed behind it. If your machine has electronic sensors (little glass bulds located in same area) your paper feed sensor may not be bad, just dirty, they can be cleaned with a q tip with a little ...
jammed behind switch. If the unit has an electronic sensor it may simply need to be cleaned with a Qtip dipped in rubbing alchohol. If neither of these help your paper feed sensor or your pc board has
jammed behind switch. If the unit has an electronic sensor it may simply need to be cleaned with a Qtip dipped in rubbing alchohol. If neither of these help your paper feed sensor or your pc board has
...jammed behind switch. If the unit has an electronic sensor it may simply need to be cleaned with a Qtip dipped in rubbing alchohol. Sensor is usually located in the center of the paper feed opening. ...
...jammed in the shredder. Won't restart. Could it be a burnt fuse? Can you send a copy of the page from the manuel dealing with this problem OR do you have a solution? Check out this video below. I ...
...jammed the shredder pretty bad. Is there and easy way to unjam? It's a 480 powershredder. First UNPLUG THE MACHINE. Unscrew four (4) screws, two in front underneath top cover and two in back of top ...
Question about Powershred 480 Shredder
...jammed with paper. Using a thin probe underneath to push out the paper and forceps on top to grasp and take it out, I cleaned out every bit of paper from each rotating pair of rolling blades. Pushing ...
...bad. Try cleaning them with a lightly moistened swab or compressed air. Fellowes will sell you the parts. I wish the instruction manual would have talked about cleaning the sensors. I took the whole ...
...JAMMED WITH PAPER.WENT TH SHRED ENVELOPES AND TOO MUCH PAPER WAS INSIDE.hOW DO I UNJAM THIS? iVE TRIED REVERSE SLOWLY THEN FORWARD,ETC.IT IS STUCK BADLY.I SAW AN ANSWER 'YOU NEED OIL PLIERS" BUT I ...
Question about P-48C Cross-Cut Paper Shredder
bad gear where it was split and it would run fine backwards, but not forward. the gear is available online. it was also clogged with paper, which must have caused a lot of torque on the gear. they are
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions