Question about WorkCentre C2424DN All-In-One Laser Printer
...as usual, xerox says shut down and call a service. Hi Ian_a_nicol: error code # 37,030.48 means X-axis motor disconnect. The X-axis motor (second phase) is not drawing the expected power from the ...
Question about WorkCentre C2424DN All-In-One Laser Printer
...including "clean smears". still not working. There are three typical reasons for fuzzy text 1. Y-axis drum rotation problem. 2. Wrong drum temperature. 3. X-axis movement problem. Sometimes the ...
Question about Phaser 8560DN Laser Printer
...is 185 miles away. I'd appreciate any suggestions. Hi tonyswain: This is your problem. Run the Y-axis Drive test. 2. Check the current values. 3. Are the values within normal operating range? Go
...fails and no apparently problem is evident, replace the preheater. 05,002.42: Problems with the Y-axis. It could be the belt,motor or the drum.7,008.4x: PM_FAULT_HEADTILT_NOT_ ENGAGED The printhead ...
...fails and no apparently problem is evident, replace the preheater. 05,002.42: Problems with the Y-axis. It could be the belt,motor or the drum.7,008.4x: PM_FAULT_HEADTILT_NOT_ ENGAGED The printhead ...
...fails and no apparently problem is evident, replace the preheater. 05,002.42: Problems with the Y-axis. It could be the belt,motor or the drum.7,008.4x: PM_FAULT_HEADTILT_NOT_ ENGAGED The printhead ...
...fails and no apparently problem is evident, replace the preheater. 05,002.42: Problems with the Y-axis. It could be the belt,motor or the drum.7,008.4x: PM_FAULT_HEADTILT_NOT_ ENGAGED The printhead ...
..."0" then "Start", enter System settings->CE Settings->MFC->Regist, enter 102 to adjust x-axis or 101 - y-axis, adjustment range x (-24 to 127), y (-72 to 72). 24 bit = 1mm. Good ...
Question about Phaser 8860MFP/D - Multifunction - color - solid ink - co... InkJet Printer
07.010.43:430009 This error indicates the Printhead was unable to tilt normally on its axis. Check for spilled ink around the printhead that prevents it from moving right to left. The printhead could ...
...restraint. Broken process drive mounting posts (repair using 604K55230 Post Repair Kit). Failing x-axis motor or motor drivers (x-axis motor can't maintain printhead's x-axis position) If there is
Usually answered in minutes!
534 Questions
436 Questions
284 Questions
267 Questions
262 Questions