CV joint on a AWD Chevy van and did the same thing so i could still use it, and then replaced the CV joint when the weather got better. Good luck and hope this helps. No, never drive without cv shafts
Question about 2000 Dakota Quad Cab
...case end of the half shaft on 2002 Dakota AWD 2002 Dakota awd CV boot on the transfer case end of the half shaft is torn Is there a replacement CV boot? Thanks Yes. Any parts store should have
...CV Half-Shaft Assembly] New} Front Left; AWD w/A.T. or FWD $50.79$0.00$50.79 CARDONE SELECT Part # 663375 {[CV Half-Shaft Assembly] New} Front Left; AWD w/M.T. $50.79$0.00$50.79 CARDONE SELECT Part # ...
1997 awd astro.trying to remove cv axle shaft.cannot get end of shaft to clear hub.suggestions? you have to undo the lower ball joint to swing the knuckle out of the way.
as soon as it moves makes a very heavy clunk & worse in reverse. remove front shaft & it quits. Clunk same if turning of not. cv joint in front shaft is bad
...AWD endevor. I was going down the road and then the rpm's started to shoot up along with the speedometer. But I was not accelerating, when I put it in park and made a huge clanking noise. It ...
Question about 2012 Legacy 2.5i Sedan 2.5L 4-cyl. AWD 6-speed Manual
...cv joints. If so then one shaft may be longer than the other and binding up on cornering. Check that the wheel bearings have been properly adjusted . IF you replaced the 1/2 joint on the shaft still ...
Question about 2002 Astro
AWD permenanlry The CV axle stub (end with the axle nut on it) supports the wheel bearing, removing the axle then driving on it would cause the bearing to wear prematurely. I would not recommend this.
Question about 2002 Astro
...Loud DriveTrain Noise Nov 18, 2010 Front drive shaft CV Jul 21, 2003 AWD System For the Explorer Apr 8, 2003 "98" Explorer making scary noise. Mar 20, 2001 More results from ...
Question about 2002 Astro
...AWD The front drive shaft is always spinning he just wants to know if its a all wheel drive Look under the car. If you see axles or cv shafts leading directly to the middle of the wheel, then it's ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions