Questions & Answers for: auto dry control

...auto dry cycles, the cycle is controlled by moisture sensing bars located on either the rear or front bulkhead, ( visible inside dryer ) if the moisture sensor bars are shorted together (normally by ...

...auto dry" features are controlled by a thermostat that is in line with the timer motor. If you have a gas dryer especially, a clogged or obstructed vent will stall the auto dry feature. If you can ...

...auto dry you may need to clean the sensor or you may have a fauilty one ...Auto Dry Loads dried using the Towels, Heavy Duty, Normal, Perm Press, and Delicates cycles will dry automatically at the ...

...auto dry cycle indeed use moisture sensors for the auto drying to work. The problem is absolutely associated with the failure of the moisture sensors, especially when the timed dry cycle works fine. ...

...auto dry sensor. Could be lint buildup around the motor and blower wheel causing the motor to overheat and shutoff. Try a timed dry setting and see if it runs through the cycle. If so, the auto dry ...

auto dry not cutting off when clothes are dry Go to http://fisherpaykelparts.net/techhelp/fisher-paykel-top-load-dryers-us-models/ This forum will work you through your problem. Your problem should ...

Auto dry features are not shutting off as they were before. No matter If I select Auto Dry Regular or Auto Dry Wrinkle Control, it will blast high heat forever (just was found running for 8 hours!) So

...AUTO DRY LEVEL for 3 seconds. Control Locked glows and a single beep tone is heard. To unlock, press and hold AUTO DRY LEVEL for 3 seconds. The indicator light turns off. Hello & Welcome to FixYa ...

...auto dry setting when it shuts off early? or is it the timed dry setting if auto dry the sensor bar in the front of the drum very possibly built up with stuff on it and telling the control its dry ...

...Auto Dry Level for 3-4 seconds this should unlock the controls. If not, this usually indicates a stuck button on the control panel. Feel the push-in action of the Auto Dry Level button to see if it ...