Questions & Answers for: audio amplifier protect mode jbl

Question about GTO 301.1 Car Audio Amplifier

1 Answer

...protect mode my amp keeps switching on and off from power to protect no matter if the car is switched on or off and even if the music is loud or quite. what can i do to get it working properly? First ...

Ad

Question about GTO75.4 Car Audio Amplifier

1 Answer

jbl 8 inch subs and they just stopped working the 3 blue led's will flash and the speakers make a thump at random intervals and the lights in the car will dim at the same time It's likely that the amp

Ad

Question about GTO 301.1 Car Audio Amplifier

1 Answer

...protect mode i have the JBL gto 301.1ii amp. i only have remote power and ground hooked up and its in protection mode never comes out i really need this amp workin due to buying ma audio subs ...

Question about BP1200.1 Car Audio Amplifier

1 Answer

...protect mode Hi there. I have a JBL Grand Touting 600 watt rms amp and it is pushing two kicker 15's. It worked fine for about 6 months and then all of the sudden it stopped working and the amp went ...

...protect mode throw a speaker on it that you know works and if it doesnt trigger the protect circuit then you probably have a blown or almost sub. Disconnect all speaker connections and rca cables. ...

Question about GTO 1201.1II Subwoofer Mono Amp - 800W Grand Touring Series Class D 1100 Watts @ 2 ohms Car Audio Amplifier

1 Answer

the amp goes in and out of protected mode could be the sub wired incorrectly to the amp.i have had same problem and used same fix. everything has been workin fine ever since. check out this link an ...

Question about GTO 601.1 Car Audio Amplifier

1 Answer

protect mode is on what could be the problem its not fuses checked that There could be a number of reasons the protect light is on. Blown speaker, blown amp, overheating, ohm load is to low and the ...

Question about BP1200.1 Car Audio Amplifier

1 Answer

protect mode, it probably has shorted output transistors. To eliminate other possible causes, do the following. Disconnect all speaker wires from the 'amplifier's speaker terminals' and disconnect RCA

Question about BP600.1 Car Audio Amplifier

2 Answers

...JBL 600.1, pushin' a PB 12, which seems to work great, was working fine yesterday. I was driving around yesterday running errands system was working fine, drove down about a 1/2mile section of ...

ve found a couple of sites that may be able to help with your problem. 1. > How to Troubleshoot Dead Sub Amplifier Car Audio 2. > Amp in Protection Troubleshooting Trust this helps, regards Alan

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...