Audi A6 Quatro 2.8 L, How do I position the crankshaft and the camshafts to install the timing belt? Where are the alignment marks for the cam shafts? How do I setup the crank shaft for TDC? Do I need
...Audi A4 2.6 V6 engine code ABC - need advice on how to do the valve timing settings with No.3 at TDC; both heads returned from the machine shop after being skimmed incorrectly set up. When stripped ...
need timing belt mark for audi a4 2.8 Fig. Crankshaft pulley alignment location for TDC-Audi 2.8L V6 engines
...audi a4 and I had to change the thermostat well I took the left side of my timing belt off and my camshaft sprocket moved clockwise it was marked I moved it back to the markers and put all back ...
...audi A6 2.4 v6 multi valve with the timing belt off, I need the cam postions at tdc 1 There should be a place on the front of motor either the left or right side that will show you when it is a TDC. ...
...audi"s are on the cam sprockets. large holes on the lobes of the camshaft gears are supposed to face each other when cylinder 3 is at TDC the crankshaft has an arrow that needs to be aligned as well. ...
Audi a4 19tdi wat position should cam b for cam to b tdc On the 1.9 liter engine remove valve cover the cam is slotted on the back place a 1/4 piece metal across the head this will be tdc
Question about 2006 A4
must the timing marks on a audi A4 2.0 B7 2006 line up or be one tooth back They all have to line up with the TDC at zero
Computpotorbox on 1997 audi replaced but will not start check tdc sensor and immobilizer in dashboard.
Question about 2001 A6
...Audi A6 Quattro, 2.8l 30 valve. How do I set the cams and crank timing without damaging the valves when the timing belt was removed with the engine not on TDC Remove the spark plugs and measuring the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions