...starter cuts in when the engine is running on my 01 fxd and on one occasion the bike started on its own after i stopped it although the key was turned on, also the back cylinder cuts in and out ...
...starter rope in the wrong direction (when facing the internals - counterclockwise) and also put the pawl (metal thing that pops up and engages the shaft pulley wheel) in the incorrect slot (rightside ...
Question about 2004 XL 1200 C Sportster Custom
...windy blowing around sand but from what i see the starter is self contained so i don't think that could be a factor. try taking apart the switch assembly and make sure the switch is not ...
...switch on and press the starter button. Watch for the spark plugs to spark. If you don't have spark, you have an ignition problem. Check your ignition coil, your "Run/Stop" button, and power to the ...
...switch and one from the starter solenoid, make sure you have them on the right post of the relay. If your solenoid came with instructions, make sure you have the wire from the solenoid connected to ...
...starter switch on 2006 Sportster 883 To replace the starter switch on your bike, you must disassemble the right hand swith assembly on your bike. Start by loosening the throttle cables. Loosen the ...
...switch and the petcock. Still even with the vacuum line connected, you won't get fuel until you turn the engine with the starter. The engine must turn to generate the vacuum to open the petcock. If ...
...Switch not cycled to Off and then back to on. 5. Starter control circuit, relay or solenoid faulty. 6. Electric starter shaft pinion gear not engaging or over-running clutch slipping. 7. Security ...
Question about 2000 FLHR-FLHRI Road king
...have just rewired your bike. if you have a electric starter then just add another from the 2cnd post (key switch) to the starter button, then 1 from the starter button back to the
Question about 2008 FLHTCU Ultra Classic Electra Glide
switch. 8. Faulty starter button. 9. Faulty kickstand, clutch, neutral safety switch. 10. Security alarm needs a reset. 11. Starter relay, solenoid, starter motor or circuit wiring faulty. 12. Starter
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions