Questions & Answers for: aqualink rs2 6 water sensor

Question about AquaLink RS2/6 All Button Dual Equipment -

Just replaced the heat exchanger, when I tried to

...a "water sencer open" message. Instructions say heater will not fire when the message is showing, whats the fix? sensor? when they work at the heater they pulled and disconec wires inside the ...

Question about AquaLink RS2/6 All Button Dual Equipment -

1 Answer

Heater reads spa water 15 degrees higher than it is

...heater all the way up to 104 the system will control the temp Double check to make sure he put the sensor on the inlet side of the heater. Sounds like you are reading temp of water leaving the

Question about AquaLink RS2/6 All Button Dual Equipment -

1 Answer

Spa sensor shorted

...water temp sensor attached to the plumbing is bad or the wire to it could be damaged. Try replacing the temp sensor. The diagram inside the control panel door tells you which wires to remove from the ...

Question about AquaLink RS2/6 All Button Dual Equipment -

0 Answer

Water temp is incorrect, reads 117 F. Air temp reads correctly.

Water temp is incorrect, reads 117 F. Air temp reads correctly. I have swapped the air and water probes but the problem stays with water. What should I try next? need new water temp sensor

Question about AquaLink RS2/6 All Button Dual Equipment -

0 Answer

Water sensor opened ?

water sensor opened ? if water sensor opened shows on heater then heater sensor bad if shows on aqualink the one on the pipe coming from filter is bad replace