...starter came apart/ worn through insul. so electricity not getting to starter. Engine locked up - starter can't turn it (bad news) Call the dealer or mfr about a service manual, or look up clymer ...
...or out to far apart that they don't reach each other. The other problem is that if the starter gear was to far apart, it may have shaved the teeth on the starter gear causing your engine not to
...starter motor? If there is voltage on the motor and it doesn't turn, is probably needs new brushes and the commutator may be dirty. I had the same issue I took apart my ignition and that is where the ...
...apart from the starter motor and replaced without having to remove the starter motor. The specific location, and design of the solenoid varies from car to car, but it's function remains constant. ...
Question about 2000 FXDWG Dyna Wide Glide
...starter motor to come apart as the two long slender bolts that you removed also hold the sections of the motor together. The same when you install the new motor. It will come apart and unless ...
Question about 2000 FXDWG Dyna Wide Glide
finally using both hands one at each end of starter gently pull out starter. You do not want starter to come apart which it very easily can thats why the use of both hands. Good luck and have nice day
starter casing-couldn't turn over any more. Pulled back apart to make sure timing chain on correct, it was. Same results as first time but stopped before I blew another starter. Not even a pucker or a
motorcycle upright). If it spins, take apart the starter switch and clean the contacts. Finally if that doesn't do it, you need a new starter solenoid. If it doesn't spin, you have a bad starter motor
Question about 2005 Vinson Automatic 500 4X4
apart and check the starter solenoid to see if the copper disc is burned and needs to be cleaned and lubricated. Also, then take apart and check the starter motor, to see if it needs to be cleaned and
Question about 2005 Vinson Automatic 500 4X4
apart to replace starter cluch was apart for about a month to replact light will come on but starter wont even click is there an oil sensor? If it only clicks when you try to start it your first check
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions