Questions & Answers for: amps 300 watts

...300 watts RMS at 2 ohm. that amp should work fine with those speakers,just make sure that they(speakers)are wired for 2 ohms.at 500-600watts coming from amp, you should be getting 250-300 watts per ...

behringer 1508 into 2 300 watt 8ohm speakers will behringer 1508 into 2 300 watt rms 8ohm speakers will the amp blow the speakers you got to stating your processor, the amp, the preamp, the speakers ...

300 watts RMS, and connect your subs to it in parallel, don't pay attention to peak watts, look at RMS watts, or continuous watts. If they're 2 ohms, buy a 2 ohm stable 2 channel amp that puts out 125

...300 watts RMS is a little on the low side, but it'll power the sub. The sub is rated for 500 watts RMS. If you haven't already purchased the amp, I'd recommend considering one with a little more ...

...Peak? thank you. Watts = Voltage x Current 300 = 12 x Current Current = 25 amps Sounds like a 30 amp slo-blo fuse would be about right -- you could start with a 25 amp and see if that holds it. ...

...300 watts rms at 4 ohms. This will give you a total impedance of 2 ohms, and your amp will put out 600 watts rms at that impedance. That way, each sub will receive 300 wats rms. I would not recommend ...

...rms is 125 watts, an amp running 300 watts is perfect and you need to wire it in series to pull a 4 ohm load from your amp. if amp is larger than 300 watts rms it will kill the w0's in a quick

...amps= watts.20 amp breaker x 125 volts = 2500 watts.However, electrician use the 80% rule, so multiply 2500 x 80% = 2000 watts.So if you have 20 amp breaker, and 12 gauge wire, and 20 amp switch, and ...

...300 watt amp to push it yes, but you would not get the same performance as you would if you gave them the suggested power. I have found that it is always better to use a more powerful amp than your ...

Manual for a jensen 300 watt power inverter Maunel ...