Question about Combination Disc/Drum Brake Lathe
...AMMCO BRAKE LATHE IS CUTTING EVEN,BUT LEAVING SMALL GROOVES IT WAS WORKING FINE UNTIL YESTERDAY.I CHECKED EVERYTHING I KNOW INCLUDING NEW BLADES' PLEASE HELP The problem isn't clearly explained. but ...
ammco 4000 lathe? I am a brake lathe technician. To change the drive belt on an Ammco 4000, you must first remove the 90 degree angle PTO (power take off) gear assembly which is driven off the back of
replaced belt on 4000 lathe and now I have no fast feed. I think that you really need to source the manual for that machine.
...ammco 3000 brake lathe to a 4000. Parts needed? Yes, an Ammco 3000 brake lathe can be converted over to a 4000 model--most any year 3000.... preferably the later years after 1970. The problem with ...
ammco disc rotor feed stops 2 inches before end of travel Most likely you have a stripped out "disc feed screw." This is a common problem I see several times a month in the field. The stripped out ...
Question about Combination Disc/Drum Brake Lathe
AMCCO 4000 BRAKE LATHE CHATTERS WHILE TURNING ROTORS Not enough rigidity, wrong speed, wrong feed rate, wrong depth of cut, wrong or dull tooling...
Question about Combination Disc/Drum Brake Lathe
...lathe, the disc feed is not working I can move the feed shaft in and out by pushing or pulling on it. It will not feed be turning the handle. The cross feed drive shaft is connected to the cross feed ...
Question about Combination Disc/Drum Brake Lathe
...tax and shipping from an Ammco depot. You can ship a broken Infimatic gearbox to our shop for a complete rebuild to factory spec. For more information... Buy Sell Used Brake Lathes Brake Lathe ...
Question about Combination Disc/Drum Brake Lathe
...will feed to the end of most smaller rotors but will only feed till a certain point. The feed reel constantly spins and doesn't stop ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions