Questions & Answers for: ammco 4000 parts

...AMMCO 4000 BRAKE LATHE AND WOULD LIKE TO KNOW HOW TO ADJUST THE DRIVE BELT. I CNAT FIND HOW TO MOVE THE MOTOR BACK. ...

...Ammco is their "El-Cheapo" model. Yeah, they work, when they work that is. I doubt that your problem lies within the spindle bearings. But it could-- I suggest that you tug on the spindle to see if ...

ammco 4000 lathe? I am a brake lathe technician. To change the drive belt on an Ammco 4000, you must first remove the 90 degree angle PTO (power take off) gear assembly which is driven off the back of

...ammco 3000 brake lathe to a 4000. Parts needed? Yes, an Ammco 3000 brake lathe can be converted over to a 4000 model--most any year 3000.... preferably the later years after 1970. The problem with ...

...4000 brake lathe, the disc feed is not working I can move the feed shaft in and out by pushing or pulling on it. It will not feed be turning the handle. The cross feed drive shaft is connected to the ...

ammco 4000 longtravel g/box adjustment not working properly,variable speed adjustment works slowly,then when increased starts to work backwards when variable speed is increased the travel starts to ...

...Ammco 4000 brake lathe and the arbor was not installed in it. The one they gave me has surface rust on it. It will not fit into the spindle either. I'm not sure on got the correct one. What is the ...

...will feed to the end of most smaller rotors but will only feed till a certain point. The feed reel constantly spins and doesn't stop ...