...aluminum heat sink with a pair of large IC`s (STK-392-040) screwed to it. Mark and unplug the power connector to the board (the red molex connector). Plug the TV in and turn on the set. If the set ...
Question about GE Refrigerators
...re-install the aluminum cover, make sure that you connect that "flying" green ground wire to one of the screws used for the panel. It's necessary. All in all, about a 20 minute job. Hope this helps! ...
...aluminum cover plate to gain access to the fuse. Using a voltmeter, with the power on and switch on, measure the voltage on each side of the round fuse located just behind the cord connector. If ...
Question about PDP4225M 42 in. Plasma Television
red arrow points to the cable/connector that needs to be removed and cleaned and reconnected. This board is in the center of the monitor and under an aluminum cover (just pull it off). Hope this helps
...aluminum heat sink got bent upwards slightly when they replaced the display board. There are some metal clips on top of the heat sink for holding one of the display cables. However, I think that ...
...aluminum electrolytic capacitors on the power supply board being defective. Replacing the four 470uf 25v capacitors (470 micro farad, 25 volt) on the board usually fixes the problem. Sometimes also ...
...aluminum plate, or heat sink, underneath that sets against the metal back of the LCD panel. Here is what happened; The "spacer " turns into a "sticky goop" causing the whole pcb move towards the Heat ...
Question about Aquos LC-42D62U 42 in. LCD HDTV
...aluminum plate, or heat sink, underneath that sets against the metal back of the LCD panel. Here is what happened; The "spacer " turns into a "sticky goop" causing the whole pcb move towards the Heat ...
Question about Aquos LC37D44U 37 in. LCD HDTV
...aluminum plate, or heat sink, underneath that sets against the metal back of the LCD panel. Here is what happened; The "spacer " turns into a "sticky goop" causing the whole pcb move towards the Heat ...
Question about 42LC2D 42 in. LCD HDTV
...panel. These are purchased from other sources, not made by LG. Look into the guts of this assembly for cylindrical components with plastic foil and an aluminum top, mostly mounted vertical to the ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions