Question about MFC-620CN All-In-One InkJet Printer
...brother ink cart and do the cleaning twice. there should be magenta again. If there is no magenta after that, this could be either because of air in the system (thats why you should do the cleaning ...
...from brother. Do the cleaning cycle twice. This will extract the air bubbles out of the caps after the second time. If you dont have any success the printhead is clogged and cant be cleaned
...Brother would recommend this, but I had the same problem and it worked. I removed the ink cartridges not showing ink- and took a can of "Dust Remover" (or any can of high pressure air) and put the ...
...air which might be within the ink system (this could be the reason why you cant print mag!). It runs an extra power cleaning, too. When finished, press 7 -6 -3 then start bk copy to do a power purge. ...
Question about MFC-465CN InkJet Printer
...oem ink? you ,may check and see if the seal is still on the cartridge, if not try and take a paper clip and insert it in to the air hole on the catridge, some times it gets clogged up. brother ...
Question about Multi-Function Center MFC-240C All-In-One InkJet Printer
Brother+MFC+240c Hope this helps ... Dale Use a syringe and nail polish remover: Take approximately 1 ml of nail polish remover (which women use) in a syringe and push it with lots of air into nozzle.
Question about Multi-Function Center MFC-240C All-In-One InkJet Printer
...brother mfc 3240C. I have changed the ink cartitages and the black keeps printing faded. I have gone through the settings it hasn't fixed the problem. Light/faint prints usually are a result from ...
Question about MFC-5440CN All-In-One InkJet Printer
...Brother MFC5440CN it My printer is printing very faded, I have changed all the ink cartridges, but it is still the same Lesley Light/faint prints usually are a result from clogged ink or air bubbles ...
...printer requires all 4 cartridges to have ink. The main reason is if it starts doing a cleaning and there's no ink in the cartridge, air will go into the tubes and causes the ink thats remaining to ...
i try to print many things but it just says on the printer that back cover is open please close paper sensor is either clogged or damaged; try to blow some air into the back cover. good luck
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions