Questions & Answers for: after washer stop water continue to drip

washer clothes are still dripping wet When we wash clothes they ar still wet at end of cycle. If I spin them a second time they are not as wet. We were not able to get the agitator off to get to where

...Washer I don't know if it two different problems. Please help. The water dripping into the tub is caused by the fill valve solenoid not closing completely. The fix is to replace the fill valve. The ...

...washer that began leaking at the front of the unit. The water is dripping from the front-center of the machine. It begins leaking immediately upon filling and will continue to leak for several hours ...

...washer. If the water continues to flow, the problem is the water inlet valve. If the water stops, the pressure switch. To access either component, you need to remove the top panel of the washer. ...

...stop dripping. This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump removes most of the water) machine. First, see the Sears ...

the water was dripping into the bucket after the final rinse and leaving clothes soaked. I have replaced both hoses (they were old anyway) and it continues to do it. It stops when I turn the cold ...

washer? you have a faulty water valved solenoid. when you actuate the water lever, the solenoid opens, to allow water flow, then closes to stop it. When you continue to get a dripping before or after,

water continues to drip after washer has stopped? Hi, The fill valve has dirt in it and it will not shut off completely... kind of the opposite of these tips... Washing Machine Problems No Water ...

...Washer will not stop filling with water after wash cycle begins when washer is turned off water will drip slowly into washer bad inlet water valve the coils probably went bad can test them with a ...

washer when the tub is full and it's time to stop filling with water. If the sensor is faulty, it may not be accurately detecting the water level, which could lead to dripping. You may need to replace