...screw does what, drain/float and how to adjust back. 4. Guessing my main cause is that i have to get to the priming pump, which looks like a pain. Thoughts? Snowing out. LOL if it has a prime bulb on ...
...pressure washer. Compressor/pump run but do not build up high pressure. check filter and manually adjust pressure by screwing down---clockwise thebrassnut on the outlet side I have had a problem ...
...adjustment screw, engine stalls hard to pull start also, unless water off first.no leaks found, any idea. if you bought a new pump make sure its the correct type then check for a unloader the ...
...pressure up. Everybody says there's a cap on top of the pump that leads to the unloader valve. There is nothing on my pump that looks like that. I've disassembled every thing I could on the entire ...
...adjustment screw was cross threaded, and therefore cannot be tightned down. Everything else look fine. Also how do you remove the 6 valves out of this pump, are they screwouts or pullouts. I beleive ...
Question about 2500 PSI Pressure Washer
...is at the faucet, the machine has no pump to increase the pressure, no washer does. there is a screw on the pressure switch but if you do adjust it only a tiny amount or it will go completely ...
...adjustment made? Is there a Service manual available for this model. pressure control valves are non adjustable They operate to unload the pump when the trigger is released What can vary pressure is ...
Question about 2500 PSI Pressure Washer
...pressure that is created when the trigger of the wand is released to be re circulated inside the pump manifold assembly. They are pre adjusted at the factory and I do not recommend screwing around ...
...screw on the pump.most pressure are set for the high setting from the factory There should be some knob that is able to adjust it. It might be on the machine but it could also be on the sprayer. If ...
Question about 3800 PSI Pressure Washer
...screw needs adjustment? The carb was new in box... Open the carburetor bowl drain and make sure there is fuel in the carburetor. Make sure after you start it that you firmly push in the choke. If not ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions