kill my cars electrical system To get the electrical system back online I adjust the negative battery cable. If I repeat the steps above the results are the same. I checked the battery cables and they
...kill switch on the throttle or the kill wire is improperly or not on the brake mechanism at all. Have you tried another plug? I have had brand new ones NG right out of the box. Does the control cable ...
...kill switch there. the plastic throttle handle should have a round pin at one end which connects to the throttle cable, there is usually a plastic outer cover that is retained by a threaded screw ...
in the stop position. You may have to adjust it a couple of times. If after the adjustment(s) it still does not start, then there is a problem with the kill wire switch on the engine's control linkage
Question about 2006 XL 1200 C Sportster Custom
adjust the idle cable the same way. When finished, lock the lock nuts so the adjustment doesn't change. Now, twist the throttle wide open and release it. The throttle should snap closed. If it doesn't
...switch will contact and kill the spark. On the throttle cable coming out of the box on the handlebar, there is a rubber boot. Inside the boot is an adjustment screw, turning clockwise will loosen ...
Question about 1998 Rodeo
...kill the starter from engaging. You need to adjust the linkage. If your shifter isn't actually on the column but the indicators are there is a cable that attaches the floor shift to ...
Question about 1998 Rodeo
...kill the engine no matter how much you adjust the linkage. If the wire and switch seem to be in the correct place and the throttle linkage is working, but it still doesn't kill the engine, ...
Question about 1999 Continental
...fine but same results Runs good but as soon as I put it in gear the engine kills Possible bad switch on the transmission or some type of adjustment to linkage or cable to compensate for a worn ...
...adjust it on the handle bars it slips Mechanical issue: clutch not disengaging completely... engine off - put in gear and roll back and forth with clutch released does engine stop the bike from ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions