Question about Trane Furnace Draft Inducer Blower 115 Volt Variable Speed Fasco # A190
...and the wires to the proper two stage heat t-stat. sounds like you need the water colomon to be adjusted on your gas valve {not enough gas pressure heat strips are not coming
...heat on Cold days? If the outdoor unit is in defrost mode the compressor will be running but the outdoor fan will not. You may even see some steam rising from the coils. This mode is to prevent frost ...
Question about 9300 Smartphone
...TO GET THE DISPLAY Hi, go remove the strip and put it back again make sure its locked well if theres no change heat the mother board with a workstation coz may be components went loose when dropped
Question about 25.6 cu. ft. Side-by-Side Refrigerator with In-Door-Ice Dispensing System
...strip of metal between the freezer and fridge on my whirlpool side by side is very hot. Also, the freezer isnt keeping things frozen and the fridge isnt as cold as it should be. The temp is adjusted ...
Question about 25.6 cu. ft. Side-by-Side Refrigerator with In-Door-Ice Dispensing System
can't get temp drop coming out of Carrier unit...drops about 5 degrees only...adjusted freon, fan, still no results can you help? third visit to home If this is a heat ump or electric heat check to ...
...see a small pointer that can be moved one direction or another This will adjust for your heat and cooling override.This will tell the furnace to shut off at the temperature you have it set at. ...
...the same. I can not get panel airflow, full defrost, full heat,ect. Where do I start? The heat adjustment (temperature) knob works fine. you are sure the knob is not stripped right ....it all ...
...heat work fine but they only blow from the defrost vents. the vent adjusting knob/switch has probably lost its connection to the vent adjuster have to strip out the area round heater controls a check ...
Question about 1956 Midget TF
...adjust achoke on 1979 mg 94 cubic engine has antifreeze running through it It is 1979 mg. Migit You need to calibrate the heat mass before reassembling the choke unit. This is from John Twist of ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions