Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...cable. Hello, I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Hoover U6437-900 / U6439-900 Windtunnel Vacuum. There is a hook on the bottom of the ...
...adjust the cable, it is from the front, on the right side, it has a torz screw that you loosen, then you can slide the cable back and forth, just move it alittle back then tighten it down and try it. ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Hoover Self-Propelled WindTunnel U6436-900 cable problem The Self-Propelled WindTunnel will not self propel. I am quite sure it has to do with the end of the cable line found just under the light. I ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Self propell not working, Real hard to push. Thanks, Dean HI, Try adjusting the cable which is in the front right side. There is a screw that you have to loosen and move the cable to and fro and then ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
Hoover self-propelled wind tunnel doesn't self propel going backwards. Your self propel cable sounds like you need to have an adjustment. reccomend a service shop repair.
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...cable are in place but the carpet/floor height adjustment switch is broken. The vacuum seems to self propel on bare floor not on carpet. I am ordering the hoover lock idler arm to replace it in the ...
...self propel button are both in the OFF position. The actual switch inside must also be OFF, and the metal fitting on the end of the power drive cable should be between the two lines molded into the ...
Question about Self-Propelled WindTunnel Bagless Upright VacuumVacuum
...self propel cable does not seem to engage when working the top handle. Is their an adjustment or repair I can do? you will have to replace the handle or the cable both of them wear out with time and ...
Question about Hoover UH60010 WindTunnel Self-Propelled Bagless Upright Vacuum
...hoover self propelled vac uh60010 new in box but out of warranty. Self propelled works in reverse but not in forward when I push the vac forward. Is their an adjustment that could be made to engage ...
Question about Self-Propelled WindTunnel Bagless Upright VacuumVacuum
...out of cable sheath. Slide new cable into sheath and fasten at bottom as it was before. You will need to adjust the cable to the proper location so the transmission works properly in both
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions