...still not printing.??? Your printer is set to load from MP feeder, either you load the A4 in the MP feeder or change from the paper menu which tray you want the printer to print from . Regards ...
...A4-OK MP tray -ok. purchased in vietnam. load 35 sheets, A4 paper in bottom tray. PUBLISHER or WINDOWS same error. Windows XP.Copies OK. Delete printer, reinstall software, error continues reinstall ...
...loaded with A4 letterhead Tray 3 is loaded with A4 plain. Our accounts system requests that 1st page print on letterhead from tray 3 and 2 other copies on plain from Tray 2. Last week all was OK but ...
...A4. The tray is full of paper When you loaded the paper in the tray, did you tell it that the paper was A4 - it may be that on the printer or in the queue definition on the computer that the paper ...
...A4 - the tray is full with A4 paper and the papertray is set to A4 factory reset should fix it unless the paper size ciruit board and levers have been physically damaged (back left on the printer in ...
...A4 size. In your tray you can find 2 A4 size. Select A4R in you want to position your paper Landscape or A4 if portrait. To verify also the correct paper size, put your paper on the platen glass. ...
Question about Phaser 6125 Colour XEROX Phaser 6125 Colour Printer
...loaded with paper. All in same A4 size. You need to program the paper size for the trays my printer HP laserjet P2015, have a problem that no error light blink ready status light on (GREEN) but no ...
Question about iR 2022 Printer
A4 size loaded in tray and the sensor guide is also set in A4. default copy size is also A4. any solutions? Try to perform a hard reset for service mode . First of all clean sensor on the left side it
Question about FS-2020D ECOSYS Monochrome Laser - 35ppm, USB2.0 & Parallel Interfaces, 500 Sheet p... Printer
...tray a4 this has never happend there is paper in the printer but i cant get it to work ive tried playing around with the settings pretty much everything! but still no luck ijust want to print normal ...
...either you selected manual feed or the setting for the default try (usually tray 1) is not set to the correct paper size. In your case, make sure the green slide adjustment on tray 1 is set to
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions
