Questions & Answers for: 99 jeep cherokee crankshaft position

...Jeep doing the same thing. It turned out to be the Crank shaft senor. It would just turn off even on the highway at 60mph. If you can change it yourself you will save a lot of money. same thing ...

...Jeep Grand Cherokee 6 cyl. Mine was the Camshaft Position Sensor. Only available at the dealership and cost $85.00 at the parts counter. Easy to install - remove the distributor cap and rotor. Sensor ...

no spark 99 JEEP GRAND CHEROKEE 4.0l HAD NO SPARK CHANGED COIL ROD CRANKSHAFT POSITION SENSOR AND STILL NO SPARK Check the asd relay in the fuse block. Replace it with a known good relay

99 jeep cherokee died going down the road. will not start. has fuel but no fire 99 jeep Cherokee inline 6 137,000 miles. car stopped running all of a sudden going down the highway. still has power. ...

99 jeep grand Cherokee Laredo, engine code P320 is what came up on the ODC....which is the CPS(crankshaft position sensor) I can fix it myself but I need to know where it's located. Please any and all

...jeep grand cherokee was running fine, i parked it when i came back it wouldnt start, but turns over. i checked the ohms through the coil which are fine. but it is not seeming to get a spark through ...

...99 jeep grand cherokee larado 6 cl Right side of the engine block. A little off center towards the back. Should be sticking out the side of the engine with a plastic plug on a shaft about the ...

...bell house.had the same problem with my 99 jeep sport.the dealer said it was the pcm.but when i replaced the cps never had the recurring problem of engine stalling after 30 mins of

location remove and replace crankshaft sensor 99 jeep grand cherokee 4.0 Find sensor on back of block at the bell housing.remove hold down bolt slip out sensor

1Ho5iAKQV00 Oct 27, 2013 - Uploaded by WeekendHandymen hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo