Questions & Answers for: 99 ford windstar water pump

Windstar has a pipe that comes out of the water pump and wraps around behind the intake. It has a hole and is leaking. Can this be soldered? What pipe is this? Heater bypass. cannot be soldered/welded

Ad

...Ford Windstar with the 3.8 v-6. The problem is the anti freeze line that runs underneath the length of the vehicle to the back left side which line is inlet and which is outlet? Thank you You'll have ...

Ad

Question about 2001 Windstar

1 Answer

...99 ford windstar 99 ford windstar van is at idle I have no heat but when traveling at a good rate of speed like 60 mph it blows warm air. Check the coolant level. If it's low, what you describe will ...

...ford windstar has a leak comming from the pipe thats connected to the water pump and now my belt has broken and the waterpump I believe is frozen. can a waterpump freeze from having water put into it ...

...2002 Ford Windstar that is leaking rust colored water and it smells like antifreeze - is the water pump going out? can be the waterpump lower inlet tube, heater core bypass tube, or heatercore its ...

cant locate o2 sensor on my 98 ford windstar YOU HAVE 4 O2 SENSOR TWO O2 SENSOR LOCATED IN EACH EXHAUST PIPE AT THE INLET AND TWO O2 SENSOR ONE IN EACH IN CATALYTIC CONVERTERS.

water pump in 99 plymouth voyager 3.0 liter Disconnect the negative battery cable. Drain the cooling system. Remove the drive belts. Remove the timing belt covers and the timing belt. Remove the water

...water pump will not stop leaking.new water pump and new metal pipe we replaced water pump and metal pipe.pipe still leakes.help Did you replace old rubber O ring before reinstalling tube back in ...

...water pump on a 2000 ford ranger 2.5 5speed Water Pump 2.5L Removal Drain the cooling system. Remove the drive belt. Remove the fan blade and clutch assy. Remove the bolts and the inlet tube. Discard ...

...to the water pump, 1995 Ford Windstar 3.8L? Look close the pipe is held on by One bolt, loosen it then work the pipe back and forth to break it loose then twist and pull. I hope this helps. Take

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...