Questions & Answers for: 97 f150 brake replacement

...disc brakes Replaced rear drum brake 97 f150 4x4. A spacer/washer oval in shape with 2 notches on outer edge and a rectangular hole in center. Where did it come from? Fell out while taking drum

...97 ford keeps blown fuse 15 amp,when I step on the brake pedal,to shift out of park it blows the fuse.can someone help me out what to look for.I replaced the switch on brake pedal that wasn't it. ...

...97 f150 is running rough and dropping to 500 rpm when put into gear. it has new plugs, fuel filter, and coil packs. sounds like an IAC issue. I'd try cleaning it out with some brake cleaner, until it ...

...97 ford F-150 You bleed it like you would a normal system but you must use the boost assist to do it, in order to do this start the truck pump the brakes three times and bleed that cylinder farthest ...

...f150 and it will not shift out of park unless i pull up the council and push the bypass button... i replaced brake lights cause 2 were blown but the problem wont go away... The problem is within the ...

...97 ford f-150 and the parking lights stay on after truck off. I replaced the headlight switch but it didn't change things. are you sure it is not brake lights pull the brake pedal up to make sure the ...

...brake rebuild on my 97 ford F-150 4.6, rear drumb system with ABS and I am looking for a ford diogram, I have a chiltons but it is generic. can you help ? also there is a hydraulic union mounted on ...

...and turn signals work running lights not working on 97 ford f-150 brake lights, turn signals, and back up lights work replaced bulbs and fuses are ok any ideas? check relay in fuse block under ...

F150 2WD Pickup Part 5 How To Install Replace Front Brakes 93 97 Ford Ranger 2WD 1AAuto com Replacing Rotors with Tapered Roller Bearings EricTheCarGuy did u clean it real good and pak the new bearing

...97 Ford f150 key work in the ignition when it worked before with no problem Key doesn't work for the doors but worked for the ignition up until I went into qt and came back out and now it won't turn ...