Questions & Answers for: 97 dodge ram vacuum problems

...97 dodge truck 2500 4x4 When i brake or let off gas it dies it has a360 for motor but it will start up & do it again You have a big vacuum leak,,check all vacuum hoses and then replace or refitt as ...

...dodge ram 1500 stalls when driving I have a 97 ram withe the 5.9/360 it has ran great until this week, maybe its the cold but it hasn't been a problem in the past. The truck starts up fine idles OK ...

97 dodge ram 1500 shakes at 45 - 55 mph after overdrive I have a 97 dodge ram 1500 that shakes after overdrive at 45-55 mph. I have changed the u joints, torque convertor, spark plugs, wires, ...

97 Dodge Ram 1500 I have a 97 ram 1500 5.9. I recently replaced the actuator and the control switch on the t/c and am getting vacuum to the switch, but nothing comes from the switch to the actuator. I

97 Dodge 1500 with a pretty bad shaking at lower speeds. Feel the problem through the truck not through the steering wheel. Rough below 50. Add gas and it smooths out. Running 70 on the intersate with

...97 dogde ram dose not like to shift into 3rd gear unless i take my foot off the gas. i was told I needed to change both solenoids. can I do this myself? Is this the problem? Your description does not ...

...97 Dodge Ram 1500 5.2L Pickup has started having shifting problems. The truck has no acceleration and wants to keep dropping down a gear. When this happens the engine will hit about 2300 rpms and ...

...dodge ram 1500, A/C blower thru vent in the face switches to defrost vent with acceleration. I was told this may be the vacuum lines. If so, which ones? had this same problem on my 97 the vacume line ...

...ram 1500 360 and when i move the shifter it will not go into 4wd, the light doesn't come on or anything its like its not even there i believe it may be the vacuum lines but i dont know where to find ...

...97 dodge ram 1500 My blower motor was working but stop can't figure out why no bad fuses is there a relay I'm missing/ also while sitting at red light why is my RPMs going up and down it never goes ...