Questions & Answers for: 91 toyota pickup clutch master

...Toyota Pickup I have a completely restored 82 Toyota Pickup truck and with the ENGINE RUNNING my clutch would not go into gear. I have a Hydraulic clutch, so i pulled over and checked my Master ...

Ad

Question about 1984 Pickup Deluxe

1 Answer

...the firewall, is the rod part of the clutch main cylinder and is that what is needing to be replaced rod activates master clutch cyl and has lost the seals in the master-fluid is migrating back on ...

Ad

91' Toyota Pickup clutch not depressing/stuck. I have a 1991 Toyota pick up and the clutch initially dropped to the floor and then popped back out and now won't depress at all, it won't even hit the ...

...91 Toyota 4X4 truck. the clutch is hydraulic. Where is the fluid reservoir located? There is a small "master cylinder", forthe clutch, located on the driver side of the engine compartment, ...

...91' Toyota Tercel 4 sp tranny Does the clutch pedal feel any harder or softer than ussual?it could be the clutch and pressure plate are worn or hopefully just that the master or slave cylinder is ...

...Toyota pick up Add brake fluid to the clutch master cylinder and pump several times. You apparently have a leak somewhere. Probably the line or slave cylinder. Look for damage to the line going from ...

...,are bad. first check for fluid in clutch reservoir, maybe low. second bleed air from clutch system. if still no pressure then check master cylinder or slave cylinder. sometimes it is a simple

clutch master cylinder and clutch release cylinder. Start with the slave (release) cylinder. First take off the line and plug it with a golf tee or a short piece of hose with a bolt in the end. Remove

Question about 1994 Pickup

1 Answer

pickup that the clutch master cylinder was leaking but the rubber boot was keeping the fluid from leaking out so you couldn't see it. Peek at the master and slave cylinders (peel the rubber cup back a

...91 toyota pickup I have replaced master Cylinder and slave cylinder cant get air out when bleeding the system Put fluid in a jar. Put a piece of aquarium tubing on the bleeder zerk and the other end ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...