Questions & Answers for: 89 ford f250 start

89 F250 lariat steering locked and key will not turn. Cannot get key to turn to start engine or even to accessory the other direction. Try putting turning pressure on the steering wheel both right and

89 F250 the distributer is also new,along with the control module and coil. befor the truck would start and drive fine, after 30-40 minutes it wouls just shut off and would have no or very week spark.

...89 F250 with efi 460 the distributer,control module and coil are new no spark at first the truck would start and run fine after 30 min or so it would just die,let it sit for awhile and it would start ...

...89 f250 custom with the 7.5 460, the fuel filter was original and clogged so i replaced it but when i started the truck the pcv valve and gromet came out of the valve cover, i cant find a gromet that ...

...89 f250 starts up and runs when it is cool but once it heats up just a little it dies and won't start again, do you have any ideas? There is a little rectangle box close to were the plug wires go in ...

...89 Ford F250 W/5.0 and the volts drop to below 8 when I start it I need it to stay at or above 10 what could be draining the volts other than the battery. I would have your alternator tested. Sounds ...

89 f250 that won"t turn over, i have I have an 89 f250 that won"t turn over, i have replaced the soliniod, and the ignition. It starts with the key in the on position and I jump the soliniod with

89 ford f250 pickup with a 5.8 motor. we replaced the exterior fuel pump and pressure regulator it starts and runs a couple minutes then dies replace the fuel filters sometimes little particals get ...

89 f250 460 engine starts but when u drive it it cuts off like not getting fuel then it wont start , but after waiting a few minutes it starts , then cuts off again after a few minutes, is it a fuel ...

89 ford f250 cranks but wont start I'm getting fuel at the rail and have replaced the coil the cap and the button still not getting spark. when key is turned to on position should I have 12 volts ...