Questions & Answers for: powerstroke battery

F250 Ford 7.3 L Powerstroke Hard to Start Cold 2000 Model Powerstroke is hard to start when cold. Outdoor temperature does not get much below 50 F and it is hard to start. I don't run the truck every ...

altenator draw I have a 1997 Ford F250 with the 7.3 Powerstroke turbo Diesel. When I crank up in the morning there is a real draw or power surge. I have new batteries and altenator on it. This engine ...

when starting my 97 f250 powerstroke, starter drags and acts like a low battery. Have new batteries. It could be bad contact at either ends of the cables or it's time to replace the starter

Powerstroke won't start...acts like dead battery; clicks and rattles and hums...but it won't jump start! I hooked my 04 Camry to the driver's side battery - no joy. Tried the other side, same result -

...Powerstroke 6.0 Diesel with 27,000 miles and can't keep the batteries charged. After sitting for four days, batteries are dead again. Had batteries checked and they say they're fine. One battery is ...

Powerstroke Engine shuts off when running on wet roads. Unhook the battery cable and wait 20 minutes and all is OK again? No it is not. You need to take it into an authorized dealer to check engine ...

...more than my v-10 is that normal is it normal for 7.3 take longer to start Yes, it IS normal for a powerstroke diesel to require more revolutions of the motor to fire than for any gasoline engine. ...

...powerstroke diesel is only reading 9 or 10 volts is it my alternater? Could be the alternator not producing 13.5 volts, or it could be the battery failing and not accepting the charge. Charge the ...

...watch this ford tech's video , ask him questions . He's good ! No Start 6 0L Powerstroke ICP Leak Testing The P1000 code means the system lost battery power , did you have the battery disconnected

powerstroke i was letting it warm up at then it died and there was no electric power no dash light no horn nothing i took my volt meter it says 12.6 volte on each battery what could be wrong? ecm fuse