...61 Husqvarna chainsaw. Availability and cost? The IPL for a Husqvarna Chainsaw model 61 made on or before Feb 1980 lists pn-501 61 72-01 Here: ...
...Husqvarna 61 #5450433 made? what year was my Husqvarna 61 chainsaw #5450433 made? 1976, go to http://international.husqvarna.com/node1004.aspx it tells the whole history of husqvarna I got this ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...husqvarna 61 chainsaw. I see that there is one tab and one ring on the switch, I see the wire that hooks on to the spade connector, is the ring for a ground wire? Surely there can be just one wire ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
husqvarna Chain saw You didn't specify of its a 61 or a 61 Rancher. Here's the info you need to take to your Husky dealer. The diagram will be with the major repair kit. Model 61, then the 61 Rancher:
Question about Chainsaw Piston Kit for 61 Chain Saw
do you hawe parts for a husqvarna 254 piston end rings my mob number is 00353 85 730 98 28 The pisto is readily available from any Husqvarna dealer, the part no. is 503503701, there are also plenty of
Question about Chainsaw Piston Kit for 61 Chain Saw
...Husqvarna 61 Chainsaw Oil screw on Husqvarna 61 Chainsaw The 61 has a 4 position oil pump, the adjuster is a black plastic screw located to the top right hand corner of the pump face, just behind the ...
Question about Chainsaw Piston Kit for 61 Chain Saw
...Husqvarna 61 chainsaw I need a smaller bar for my Husqvarna 61 chainsaw and would like to fit an Oregon 14in. bar and chain - not sure which one to order online. There is a genuine Husqvarna 15" bar ...
husqvarna 268 chainsaw throttle replacement Refer this issue directly to Husqvarna.
Question about Models 61-66, 266, 268, 272
how to clean iner crank shaft casing small particles of piston stuck to walls with out spliting husqvarna 61 chainsaw not much point in doing so, engine is shot
Question about Models 61-66, 266, 268, 272
What are the Cylinder Head or all torque settings for the Hasqvarna Chainsaw 61 Torques settings for the 61: Head bolts - 10 Nm Crankcase bolts - 8 Nm Clutch - 35 Nm
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions