...started. Checked again only reading 5 volts with ignition on or when running. Fitted new dealer crank sensor couple months ago 5 volts is correct. Those sensors work off of a 5 volt reference
...Actuator The air temperature actuator is a 3 wire bi-directional electric motor. Ignition 3 voltage, ground and control circuits enable the actuator to operate. The control circuit uses a
Question about 2001 Montana
...volt referance pid on a scan tool and disconect the sensors one by one till the referance volts comes to about 5 volts if that don't work then check the wires for a short to ground ...
...5.0 volts this is reference. The other side measure the groundyou should not exceed 1 volt. If you exceed 1 volt of the signal return recheck the pin at the ECM.If connection are good the ECM is ...
...5 volt reference, check for a short to voltage from another wire in the harness. If that is no good, check the pin out from the ECM directly and see it it is pushing out too much on the reference ...
...Volt Reference 2 Circuit Some of the engine sensors on your vehicle work off of a steady 5 volt supply by the PCM - engine computer . One of these sensors is short internally bring down the PCM ...
Question about 1997 Expedition
...on my 1990 geo storm? Do you know how a TPS work's ? Three wire Thermistor-Potentiometer .Work's off of 5 volt computer ref. circuit . Thermistor Potentiometer comparison and the 5v reference ...
Question about 1997 Expedition
...volt reference can be caused by an open in the wire (check the continuity of the wire from computer to TPS) OR a short in the harness or another sensor that uses the same reference wire. White smoke ...
I got a b1318 low batt voltage code on a 08 ford escape. When turning the key the car won't crank or start. Usually takes sometime before it does. All the lights work and the battery alt and starter ...
...volt reference signal from the BCM. Whenever the brake pedal is applied, the brake pedal position sensor applies a variable voltage signal to the BCM through the stop lamp switch signal circuit. The ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions