Questions & Answers for: 4x4 working front differential dodge

...4x4 has a check engine light and ABS light on in the dash and the speedometer stopped working completely. . .it has also stalled. . . Azone says it is the vehicle speed sensor(Duralast Part Number ...

2wd works fine but when my 1998 dodge ram 1500 slt club cab 4x4 is in any of the 4wheel drive modes the front differential slips and clunks when you give it power? may be a stripped axle,

...could be intermittent. 4X4's need to have the front ends greased on a regular and generous basis. You did not mention if you had hublocks fitted, which would be another check to carry out. Good

...4x4 front differential will not engage the axle on ford? http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html ------- 4x4 will not engage on Ford F150? ...

...4x4 front differential will not engage the axle on ford? http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html ------- 4x4 will not engage on Ford F150? ...

...4x4 quit working driveing if i turn to the left just a little it sounds like a bad wheel bearing but i replaced both of them and ut a new actuator in it when i pilled the actuator off my axels were ...

...fine. 4x4 light stopped coming on and front hubs won't engage. You have a Vacuum Leak that is not allowing the Front Hubs to engage... I do believe that 1996 Dodge has Vacuum hubs on the ...

...front axel 4X4 solenoid (POSSIBLY). Also check your differential fluid and your transfer case fluid. Old dirty fluid will cause the four wheel drive to be sticky and not engage properly. If the fluid ...

...from the transfer case and engage 4x4 again, if it turns then you have isolated the problem to the front differential, if it still won't move then you know there is a problem in the transfer

...4x4. front wheel u-joints on a 4x4 That model does not have U-joints, it uses constant velocity (CV) joints. It is much easier, and usually just as cost effective, to replace the half shafts (front ...