...4L60E Transmission. It shifts great into reverse but when I move the selector over to the overdrive (4th), it does not start out in 1st gear. If I move the selector to first and start moving and then ...
4l60e transmission wont downshift back to first at stop unless you do it manually Spring behind 1-2 shift solenoid broke, or valve stuck.
...to be an electrical issue rather than mechanical. check and /or replace the siftijng solenoid what tranny do you have....if its the 4L60e then you more than likely have a bad sensor on the ...
...solenoid in the tranny (4L60E hydra-matic). Depending on the year and type of tranny this was a default setting to either only second or only third gear, should some electrical or transmission ...
...solenoid in the tranny (4L60E hydra-matic). Depending on the year and type of tranny this was a default setting to either only second or only third gear, should some electrical or transmission ...
...4l60e will not go into 3rd gear. 1,2,r and 4th work fine. i have changed the 1-2 and 2-3 shift solinods. did not find any parts in the pan or burnt fluid. the only code is for lean burn bank 1. ken ...
Question about 1993 S-10 Blazer
4L60E automatic 4 speed over drive transmission The vehicle, will shift hard from 1st to second. At times so hard that it will chirp the tires even, and piratically break your neck its such a hard ***
Question about 1998 C2500
...4l60e that was all the wires been strip off of it.. It is stuck in limp mode [I guess] all I need is 1st to move it around the farm.. Is there anyway I can wire it so it will just need 1st gear to ...
Question about 94 95 96 97 Chevy S-10 S10 Pickup Billet Grille Grill
10 Forum 30 Common 4L60E Transmission Problems Repair Charlotte NC Shift Solenoid and Tests GM 4 3L 5 0L 5 7L 95 4L60E 1 2 shift only high RPM ChevyTalk FREE Restoration and Repair... Could cost a lot
Question about 94 95 96 97 Chevy S-10 S10 Pickup Billet Grille Grill
4L60E transmission is stuck in park and in gear at the same time, it could be due to a few different issues: Shift linkage: Check the shift linkage to ensure it is properly adjusted and not binding or
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions