Question about 2001 Blazer
...Vortec fuel pressure / oil pressure relay I need some information regarding a situation with a 4.3 Vortec engine in a Chevy Pick-Up. The engine started hard, which was an indication that the fuel ...
...vortec motor. rebuilt fuel pump replaced fuel filter, when you turn it over, wants to crank, but doesn't. Where is the rollover switch located? Could it be something else? HELP!! If the engine is ...
...vortec spark is fine fuel is not replaced fuel pump wasn't it fuel filter is fine getting 5 volts to the pump- rewired - pump kicks on still no start! any clue? you have to put a guage on it to find ...
...oil pump located on 5.3 vortec 2000 silverado? How do you change? located on the front of the engine behind the timing cover. can be done with lost of paitents without droping pan. hint. set a strong ...
vortec. which pan under the engine is the oil pump located at. Is it the aluminum one or the steel one? bad news its the aluminum one the hard one have to remove the front diff to get to it if its 4x4
vortec engine. the oil filter has been moved up behind right headlite Hello goldwing0001: My name is Roger and I will be glad to help. GM moved the switch from down by the oil filter to the top of the
...vortec 4.3L Engine To Remove: Remove or disconnect the following: Engine oil pan The oil pump bolt The oil pump Inspect the pins (oil pump locator) for damage Replace the pins if required Clean and ...
vortec engine i have very low to no oil pressure and lot of noise from engine but seem to stop when i put oil in the motor most pumps are in oil pan. remove oil pan and it is attached to under side of
...pump will still get power through the oil pressure sending unit its a safety back up system but will make a long cranking condution. Also check your fuel filter located under the drivers door on the ...
Question about 2002 Bravada
vortec, Its located in front of engine, its just below the engine oil fill cap, right by the coolant hose is the camshaft position sensor (CMP)
If your looking for the camshaft positioning actuator
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions