45 minutes and the screen went blank. I tried to turn it back on and nothing happened, I replaced the batteries with new Rayovac batteries and it turned on and went blank again in less than one minute
Garmin 45 no position. I have just bought a Garmin 45 from USA as backup for my original Garmin 45 which works ok. Now in the UK it will not aquire satelites and the clock is showing the wrong time ...
..., i had 2 NUVI 660 in front of me. Did you flip the antenna parallel to earth surface. Wait 45-56 seconds and you should get a signal. If your are on vertical position with you GPS . Place
garmin_streetpilot_c330_ Do I need to purchase map updates? I was having a problem with my streetpilot about 2 years old - it was not locating satellites quickly. I had to trick it by telling it that ...
...logo before moving the switch into the Lock position. Leave your finger on the screen for about 45 seconds. Two intersecting lines should display on the screen along with the message: Press Dot. ...
Question about Nuvi 360 Bilingual GPS Navigator and Personal Travel Assistant GPS Receiver
...yet. When my unit can't locate or acquire satellites I change between GPS and WAAS mode. Within 45 seconds my unit successfully locates satellite. After some time if I disconnect unit I might
When i plug my car charger to my GPS it turns it to PC mode and im not able to use my GPS while its charging. Here is a nice trick to use the Garmin while charging with a USB cord or a wall charger: ...
...logo before moving the switch into the Lock position. Leave your finger on the screen for about 45 seconds. Two intersecting lines should display on the screen along with the message: Press ...
Question about Nuvi 1450T GPS Receiver
Garmin 1450t stuck in loader loading error after downloading maps purchased maps lifetime after download finished it went to loader loading and will not move Please follow the instructions below to ...
Question about Nuvi 1450T GPS Receiver
My GARMIN 740s turned off by itself last night, and now when I turn it on, the GARMIN logo comes on the screen for about ten seconds, then the unit turns itself off again. How do I fix this problem? I
Usually answered in minutes!
1,343 Questions
1,187 Questions
1,096 Questions
889 Questions
690 Questions