Questions & Answers for: 42cc poulan pro chainsaw replace

...poulan pro 42cc chane saw gas flow's out of the carburetor. needless to say it will not run. Gas line from primer bulb to carb may be cracked or broken. Check gas lines for damage. If not that then ...

What is the compresion for the Poulan Pro 42cc. What is the compresion for the Poulan Pro 42cc chain saw. Answered in CR

...and poulan 250 pro 42cc fuel lines rotted off. tow connectors on bottom of primer, one long in center and a shorter one to the side. which goes to the carb? kenandersen the longer one goes to the ...

will not idle. must keep gas on throttle . it's a poulan pro 42cc chainsaw replace your carburetor air filter

...Poulan Pro 42cc 18" saw? The user manual only says take it to a service center for sharpening. Hours of on line searching didn't give a result. 5/32 inch diameter round file what are the file angles ...

...poulan pro 42cc 18" chainsaw that runs I have a poulan pro 42cc 18" chainsaw that runs fine when cold but after about ten minutes of operation it won't start again? If I let it cool down for ...

...Poulan Pro 42CC 18' chainsaw and need to know how to lean out the carburator? I have a Poulan Pro 42CC 18' chainsaw and need to know how to lean out the carburator? you dont  neddle ...

...poulan pro 260 ACE Hardware has everything you need, I have the poulan also and all you need is the torx screw driver and get the little clamps for the fuel line, I got the kit which had all in ...

...poulan pro chainsaw? the lines was broken and of and i don't know where the new lines go Where do the fuel and primer lines go in Craftsman or Poulan Chainsaw Hope this helps. Also try to avoid using ...

...poulan pro chainsaw 42cc pp4218a I'm not real sure how to reinstall the throttle cable back to the carb Videos here ...