Questions & Answers for: 328i idle start

...idle my 97 328i idles rough when first started but clears out as i drive it any ideas? idle control valve,replace, low oil pressure maybe check level,eml light on,if not get plugged in and aquire ...

...328i throttle sticking in high rev. if the throttle plate is sticking clean it with throttle body cleaner with an old tooth brush. if still doing the same, it maybe the throttle position sensor is ...

...328i cuts out at idle,wont krank,runs rough at idle. had a flat battery and jumped the car, i left it running to get some charge in the battery and it was running fine.All of a sudden the engine ...

328i when i start it up in the morning the idle goes up and down then the car just shuts down and i have to start it up again please help bad compression maybe.. check ur intake to make sure it is all

...328i if let idle it runs ruff i have an 328i it runs out go at times it cuts back or if idle long its began to start running ruff The BMW 328i Firstly clean the air filter as it seems that the engine ...

...328i if let idle it runs ruff i have an 328i it runs out go at times it cuts back or if idle long its began to start running ruff could be a number of issues. like crankshaft position sensors, mass ...

...328i convertible automatic transmission. I can't seem to find where to add tranny fluid. It seems to slip or lag when going from reverse to drive. Any help will be appreciated. to check oil start ...

328i has an eratic starting problem. it will start at times ok but other time it does not. Batery check confirmrd the batery to be ok. I tried diferent keys but the problem stays. It also seems to get

...328i se manual it runs fine when cold but once walmed up it cuts out when i put the clutch in and some times revs up and down also recently a very quite ticking sound has started ??? also there is a ...

...start up, could it be idle control valve and where is iacv located on this car, it only does this on initial start with eng warm Why are you convicting the idle control valve? was it properly ...