honda 30is generator I just had my honda 30is generator serviced and it is running a little rough when the eco trottle is on (or in the eco position). It sounds like it is starving for fuel. Is their ...
Question about 3000 Watt Portable Generator
Honda generator ei3000. Will run only a few mins then stops. Checked all the fuel system. Tried brand new carb. Tried fresh fuel direct to carb inlet. Tried disconecting carb motor. Checked oil level ...
Question about 3000 Watt Portable Generator
Honda 3000 eu no spark replace ing coil still no spark Is there enough oil in the crankcase? Many generator ignition problems come from the oil level sensor. Either not enough oil or the sensor being ...
...Honda 3000 generator starts and runs for 30 seconds and turns off. Does anyone knows what the problem could be It may be old fuel and the spark plug is fouled. Old gas clogged the Jets in the ...
Question about 3000 Watt Portable Generator
honda eu3000is. runs but not putting out the full watts. Is this a cheap or expensive fix? I have the 5kw Honda and have no problem, but I have never tried to run 5,000 watts either. It is reaching ...
...3000 Watt Portable Generator Problem not getting spark to the plug i know that much because i pulled plug and cranked over nothing but i did get zapped when held plug wire in my hand just had ...
Question about 3000 Watt Portable Generator
...3000 watt honda generator doesn't seem to put out the proper power When I am running my 3000 watt honda generator to my cabin, the generator will blow fuses in my stereo and surround sound.But at ...
Question about 3000 Watt Portable Generator
somtimes when you crank the green piolt ight dont come on but turns way to many rpm then nextime you crank lights on runs perfect WHAT IS THE PROBLEM ON A PETROL GENERATOR WHICH RUNS FOR 3 MINUTES AND
Question about 3000 Watt Portable Generator
WHAT IS THE PROBLEM ON A PETROL GENERATOR WHICH RUNS FOR 3 MINUTES AND GOES OFF fuel pump, fuel filter or carb
Question about 3000 Watt Portable Generator
Running 6 400w metal halide fixtures. When they start drawing over 16.5 amps they flicker. Unplug 2 of the lights and its ok. Using the 30amp 125v recept sound like you have a problem with your supply
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions