...stroke with possible electrical problem, fired up and rode 50m and stopped, cant seem to get to fire up again. New plugs, checked wiring, disconnected kill switches, fuel draining from carb, spark ...
stroke and does not run properly. It is hard to start and then when it does seems to lose power and stop. What do I need to do to fix the problem?? May have a screen in the exhaust that has plugged up
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...problems, check the fuel lines and filter (in the tank) for condition, the carburetor is mounted tightly and all of it's screws are tight. Make sure the air cleaner is installed correctly. Make sure ...
stroke when cutting. Release the throttle and adjust L CW so that the engine idles fairly well, but will allow the engine to 'follow the throttle'. The problem with late model saws is that the EPA has
...H and L jet screws have slotted heads, turn the H jet needle CCW about 1/8 turn until the engine 4-strokes at full throttle, but immediately 2-strokes when cutting. If the jet needles have 'D'
...stroke will smoke if it has too rich of a mixture or a carburetor that has a malfunctioning choke (a new choke plunger would fix this). Make sure you have a good o-ring on the main jet holder. This ...
...oil pan or a 2 stroke with mixed gas and the plug is getting fouled? if it is a 4 stroke, then it should be stored flat. if it is a 2 stroke that is fouling the plug then it will be a carburetor ...
...stroke that starts with starting fluid but doesn't stay running what could the problem be Fuel filter. Cracked hose from fuel tank to carburetor. bad gas, sludge inside the carburetor stuck float. ...
Question about 1974 DT 360
Stroke Scooter / ATV Carburetor Settings And ... ? 4:37 https://www.youtube.com/watch?v=A1vRMERs4RQ Jun 2, 2012 - Uploaded by 90GTVert Part 2 of a 4 part video detailing all of the basic settings and
Question about 1974 DT 360
...stroke, but worth checking a few simple things : Is there an obstruction in the fuel supply ? Is the fuel tank supposed to be vented - if so, is the vent blocked ? Is there some dirt in the fuel, ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions