...remove the tweeter, and check it DC resistance. They normally have their impedance marked on the back of the magnet. If not, you can assume they should measure 8 ohms. If they measure open circuit ...
...remove the two screws holding the small plastic brace against the back of the tweeter. It's a tight fit. Don't pull too hard on the wires! Next, push the tweeter out from the front, touching ...
...Remove all the tweeter screws. 2. Take a thing metal rod (a coat hanger should work) and lightly tap the tweeter through the top port in the rear until it is loosened and comes out. The tweeter is ...
Tweeter D2904/710002 4 ohm, 1" soft dome, 70 mm diameter magnet, $220 or a Vifa D27TG35-06 6 ohms, 72 mm diameter magnet, 91 db, $37.50..Both are available from: http://www.speakercity.com/ in Burbank
...Take off/unscrew the upper bass/mid , insert your hand and gently twist the tweeter magnet assembly anti-clockwise about a quarter of a turn, and remove thru upper bass hole Peter ...
...remove the cable connectors on the tweeter terminals ( Red and Black wire ). Now if you have a multimeter put it in Ohms range and touch the probes on the tweeter terminals-- It should show a reading ...
remove the magnet from the tweeter horn in the PR15 Speakers so I can get to the 3 screws Removing a magnet from a tweeter is oftten fatal to the voice coil or element in piezo drivers. If you can see
Question about B215xl 15 Inch 2 Way Speaker Passive Full Range Speaker - Used
...Remove the 18 screws that hold the case halves together using a long shafted phillips screwdriver. I used a magnet pen to recover the screws from their long tunnels. Note that the two holes have ...
Question about B215xl 15 Inch 2 Way Speaker Passive Full Range Speaker - Used
...magnet assembly. How to undo this box? I have to remove first the subwoofer? Do I need to control the crossover? Waiting any help. Thanks check to see if you can find it on parts-express.com that's ...
Question about B215xl 15 Inch 2 Way Speaker Passive Full Range Speaker - Used
...remove it? Any tips please? Hi, The hole that was cut for the tweeter is holding the magnet. It was tight going in. And hard to get out. Take a flat screwdriver and pry up one of the edges a little. ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions