Questions & Answers for: 2006 silverado blower fan getting

...Blower, or Fan and should be 30 Amp. The one in the cab supplies switched 12 volts to the fan speed switch. The one under the hood supplies the 12 volts to the relay. The relay is normally energized ...

Silverado ac/heat blower does not work 2003 Silverado with automatic climate control blower does not run on any speed if set to recirculate. I only get air movement if I turn off recirculate and drive

...2006 silverado, the fan to the cab won't blow air. i have a 2006 silverado extd cab, the fan to the cab just stopped blowing air with no warning. Check the connector to the blower resistor, they tend ...

2006 GMC Sierra with the electric dual climate controll and the fan motor stoped working this morning. I have power going all the way to the blower motor and the blower motor works when I put 12 volts

...Silverado heater blower does not start when switched on. Give it a whack and it works at all speeds. Blower motor or relay? Disconnect the wire leads from the blower motor and check for 12 volts. If ...

2006 chevy silverado blower fan not working right. The control does not work. It still blows on low but nothing else. Cut key off and fan still blows. With one speed working it is more than likely the

2006 silverado. and how can i be sure its not a resistor Most of the time when the resistor block is faulty the fan will operate on high.This is because the high speed is a direct feed.You should also

...blower won't work on my 1986 silverado I have replaced the blower relay, the resistor looks fine, but blower won't work on my 1986 Silverado Change the resistor. For the 15-20 bucks it's a great ...

volts at the blower motor. is it the blower motor? possibly as the voltage at the motor should be only 12 volts check why you are getting such a high voltage there as it may be a faulty control module

...blower fan until you stop getting 12 volts. Where it stops is where the problem is. You can also start the test right at the blower fan with a meter to see if the fan is getting 12 volts and work ...