Questions & Answers for: 2005 taurus cranking sensor

Question about 2005 Taurus

1 Answer

theft mode when we go to start the car it sometimes doesn't start and the car goes into theft mode. We have been told to wait 10 minutes and restart, sometimes it works and sometimes we have to wait ...

Ad

...2005 ford Tarus I have changed the spark plugs and engine light went off for 2 weeks and is back on now sometimes hard to start but have found no vacume leak so what is it?? coil? or ignition wires?? ...

Ad

Taurus SHO 3.2L Failed emissions badly- hydrocarbons in grams/mile=1.68 where .80 is pass carbon monoxide in grams/mile=44.80 where 12.00 pass. oxides of nitrogen in grams/mile=1.78 where 2.00 is pass

...for my 2005 Ford Taurus. What could be causing these? 171 system to lean bank one, 174 to lean bank 2, 300 multiple miss fire,316 crank sensor defective. Does it run rough? Replace crank sensor

2005 Ford taurus. Starts fine, but won't restart after running hot for awhile. No noise when you turn the key- dead silence. Is it something electrical? Is there a sensor/ higher amp fuse in power ...

Question about 2005 Taurus

1 Answer

When I start the car, we have an intermitent "dead zone" . It either turns over and runs fine. Then the next time it cranks like it has no fire or fuel. After 2 to 4 tries it fires right up.

Question about 2005 Taurus

2 Answers

...2005 Ford Taurus with 68,000 miles on it and it sent 3 codes until the seller replaced two O2 sensors and turned off the check engine light. After about 3 cranks, the check engine light came on again ...

taurus 2005. Disconnect the ground battery cable using a wrench to hold the terminal bolt in place as you loosen the retaining nut with another wrench.Locate the accelerator cable next to the throttle

Engine Code PO 300 and PO 316 came up when running diagnostic My Car intermittently will not start on the first try but usually does on the second try. Also I here a clicking sound at the instrument ...

when replacing crank angke postioning sensor the arrow on the hesd of the tool should it be linded up with the the hold down bolt? do you have the haynes repair manual for it ?

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...