Questions & Answers for: 2005 pt cruiser problems o2

2005 chrysler pt cruiser? Where is the crank sensor located on 2005 chrysler pt cruiser? the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could

2005 Pt Cruiser idles rough at stop lights/ poor gas mileage. I have a 2005 Pt Cruiser that acts like the engine wants to cut off when I stop at red lights. Plus the car only gets about 250 miles to a

...2005 PT cruiser. I replaced both sensors, reset codes. 1 day later same codes appeared. What could this mean? I had a similar problem with my car. It turned out the O2 sensors were fine and the issue ...

2005 PT Cruiser showing P0456 and P0522. Cranks but wont start. 2005 PT Cruiser turns over but will not start. It acts as if it isnt getting spark. I checked for codes and it shows P0456(Which is Evap

2005 Chrysler PT Cruiser Turbo. Had both O2 sensors replaced but check engine light continues to go on and off. The car drives well, just the check engine light. Don't know what to do next the

code p0031 Code 31 is for a problem with the heater circuit for the O2 sensor in front of the catalytic converter. The circuit would need to be checked.

...2005 PT Cruiser? your upstream o2 sensor is located behind motor and manifold and need an o2 senor socket and racket plus extension to remove and then your downstream 02 sensor is on the side of Cat ...

...pt cruiser 2005 and still in the diagnostic problem cam sensor change cam and crankshaft sensor and still in the diagnostic problem cam sensor just remove the battery terminals for a while firstly ...

...pt cruiser check engine ligth on code at autozone p0132 where is it located? can I change it? its the o2 sensor behind motor on top of exhaust manifold. very easy to get to. the Upstream O2 sensor is ...

...on a 2005 pt cruiser how to install and location of knock sensor Link is for a 2003 PT Cruiser, but should be the same for your 2005. 2003 Chrysler PT Cruiser Changing Knock Sensor Engine ...