Mustang 2005. After changing the stock radio by a Kenwood KDCBT6544U, the transmission goes in limp mode. Changing back to stock did not resolve the problem. what went wrong, and what needs to be done
2005 Mustang speedometer sometimes zeroes itself at 10 to 20 mph when cranked. Sometimes works fine. ok got it. I have seen this problem at the ford dealer, here is what we have found, the needle is ...
...2005 ford mustang gt? I'm not sure if that happened or not but it was slow to start and 2-3 miles from the gas station everything started shutting down, ie, traction control, airbag, radio, then lost ...
2005 Mustang 4.0 electrical problem 2005 Mustang 4.0 I had the alternator rebuilt at a local shop. Now the headlights will go off by themselves, heater fan sounds as if it goes from high to lo and ...
2005 Mustang GT emission control light emissions control light is on. Previous diagnosis indicated cam shaft position sensor, replaced cam shaft position sensor, cleared codes, light comes on again, ...
...2005 Ford Mustang GT and the code reads: Circuit A, Cam Shaft Position Sensor. Then my RPM gauge worked then stopped working then worked then not. I was driving my car and the stereo and AC quit ...
Question about 2005 645Ci Convertible
83 mustang convertible top won't go up or down/what's the problem? what could be the problem? we tried to bring the top down on our 83 mustang convertible top and weren't able to, then tried to bring ...
the engine starts but does not accelerate Sounds like the throttle by wire system isn't working. If the check engine light is on get the code. U can go to autozone or advanced auto to get this service
Question about 2005 Mustang GT
...2005 Mustange gt convert. power seat moves forward but not back if there was no electrical work done on it you don't need a diagram it sounds like you need to unplug the seats connector clean it and ...
Question about 2005 Mustang
2005 ford mustang shows code p0446 what is the problem and how to fix EVAP (Evaporative Emission control system),canister vent solenoid or control circuit malfunction. Make sure your ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions