Questions & Answers for: 2005 ford taurus fuel pump

2005 Ford Taurus SE 3.0L V6 OBD Codes P0171 and P0174 Was getting fault code P0420, so I replaced all four O2 sensors with Bosch models. Also replaced plugs (Motorcraft platinum) and plug wires ...

Ad

...2005 Ford Taurus along with the check engine light coming on. Any idea what I can do to fix it? The gasoline tank should be lowered and the sending unit and gauge should be replaced. The fuel pump is ...

Ad

2005 Ford Taurus this morning (the temp was 1 degree) and at first it started up but immediately died. I tried a couple more times but it wouldn't start. The engine cranks, but doesn't get enough push

Question about 2005 Taurus

1 Answer

...Fuel pump has been replaced including fuel level sensor. Still same problem. Acts like a short but where. You will need to check the connector to the fuel tank, this sounds like a poor connection not ...

...taurus spits and sputters on startup when cold when starting after sitting over night or a day or so . the car will spit and sputter and almost die out and then all of a sudden revv up for a 5 to 15 ...

...ford taurus 2005, losing power after being driven for more than 30 consecutive minutes Hi Troy, I suggest having a diagnostic scan carried out. If nothing registers on the scan have the fuel pump ...

on a 2005 ford taurus can i just replace the fuel pump and strainer are do i need to replace the fuel pump and housing assembly? Most shops replace the entire fuel module.

...2005 ford taurus when i turn the key on i don't hear the pump run what could be the cause? i backprobe the number 2 wire at the fuel shutoff switch i didn't hear the pump run what all i need to check ...

...2005 ford taurus. the fuel pump relay have numbers on it and they are #1, #2, #3, #4, #5 but i don't know which number to connected the Jumper wire to. i think the fuel pump relay is number 29 in the ...

Question about 2007 Shelby GT 500 Convertible New Cars

1 Answer

...2005 https://www.troublecodes.net > ford > edge-five-hundre... Trouble code identification ; P1128, Heated oxygen sensor (H02S) 1, bank 1/ bank 2-interchanged, Wiring, connectors swapped ; P1129, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...