Questions & Answers for: 2005 ford escape 3 v6

...ford escape V6 began hesitating and missing at O3 ford escape V6 began hesitating and missing at idle in drive, also misfiring at 2000 rpm while driving. It used 3/4 of a tank of fuel going 70 miles. ...

2005 ford escape xlt awd v6, vehicle "jerks" as it accelerates from 0 to about 40mph. First few "jerks" are hard then then get a little smoother, until 40 mph is reached. When ...

CODE PO511 ENGINE MISFIRE- NO PWR P0511 is set when there is a circuit problem with the idle air control motor. There are 2 wires that go to the idle air control motor that could have a open or the ...

Where is the starter located for a 2005 Ford escape 3 liter v6 What can cause an escape not to start,i hear clicking when trying to start? Having a problem locating the starter on a 2005 ford escape

cylinder layout for a 2005 fors escape v6 need V6 cylinder numbers 1 2 3 is the rear cylinders and 4 5 6 are in the front if I'm not mis

Cause for the abs and 4*4 light blinking on the panel/ford escape v6 2005 needs to have scan tool applied trouble codes indicated reason for flashing

2005 ford escape v6 code 0353 coil C and 0354 coil D. which one is C and which one is D Coil C and coil D are cylinder 3 and 4, # 3 is the last coil on the passenger side, #4 is the first coil on ...

I have a 2005 Ford escape 3.0 v6 XLT what size oil sending unit do need to use 1/4 or 3/8 Easy way to tell is to remove the current sending unit and find out.

2005 Ford Escape XLT V6. Where does each hose connect to the radiator please? There are 2 small hoses that attach to the bottom driver side part of the radiator. One of those connects to the bottom of

2005 Ford Escape V6 only get 1.5 volts at the starter. Battery is fully charged and a new starter installed. Fuses and relays appear good. Any suggestions? Thanks in advance. Connected a Foxwell code ...