...knock them out while replacing the rotor and brakes. my abs light is on, computer says rear housing abs sensor is out, I replaced abs sensor with new ones, but still have same problem. so i ...
KNOCK SENSOR KEEP GOING OUT CHECK ENGINE LIGHT COMING ON TESTED IT IT READS KNOCK SENSORS WHAT CAUSES THEM TO GO OUT I HAVE REPLACED KNOCK SENSORS INTAKE GASKET AND THE WIRING HARNESS TO THE KNOCK ...
...them do a sensor test start the car on a hoist then tap the engine or if posable tap the timing sensor and also try shaking the wires running to the knock sensor and the tining sensor or ...
Oil light keeps coming on but doesn't stay on. Flickers occasionally. Can go few days without it going off and then it will appear. Checked oil level and all is well. Your sensor may be going bad, or ...
...knock sensor on the top of the engine. The sensor is located on the passenger’s side of the engine block about halfway back and just below the cylinder head. 2 Disconnect the wiring harness connector ...
Question about 2004 9-3
...2004,my car ignition control module was damaged so replaced. Just after replacing my car shaking while driving or idle. Mechanic told i need to change plugs wires and some filt first my car got heat ...
Question about Saturn L100 L200 LW200 L300-1 2001 2002 2003 2004 A/C Condenser Cooling Fan Assy w/ blades, motor, & shroud OEM: TYC 610640, Interchange : GM3113115, Other : 15867597
knock sensor in my 2001 Saturn Lw200, where is it? Just a guess but is typically on top of intake manifold and may have to remove down to intake to access it but should be able to accesss the wires to
2004, 2wd, 3.3 with 147,000 miles won't start. i was driving the other day when it just died. it felt like i ran out of gas. towed it home. BINGO! i check for fuel pressure. it's done. so i change out
2004 chryser pacifica coil not firing coil is good Do you have engine management light lit up on the dash? FUSES, FUSES, FUSES and then, sure it's not a fuel problem, coil ro to N#1 spark plug, test, ...
Question about 2004 Frontier XE
...2004 3.8 to a 2002 3.3 After swapping engines I have no spark except the occasionally backfire. the crank and cam sensors work. I am getting a signal to the computer from both the cam sand crank, I ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
