Questions & Answers for: 2003 saturn ion clutch cylinder

Question about 2003 ION

1 Answer

Ion clutch I have an 03 ion-1 and it will not go into gear. I can start the car in N and then I can't put it in gear. Or I can start the car in gear and as long as I give it gas, It will go but then I

Ad

...housing 2003 saturn vue 98,000 miles wont go into gear ,the clutch has no presssure The slave cylinder will have to be replaced and air bled from the system to make this repair. Good ...

Ad

Question about 2003 ION

2 Answers

...cylinder. Every other time, have the person operating the clutch pump the pedal a few times before holding it down. Once the slave cylinder is sufficiently bled, repeat this process on the master ...

Question about 2003 ION

1 Answer

...ion clutch goes all the way to the floor how do i fix this problem? The system may be out of fluid, The loss of fluid may be from a leaking clutch master cylinder or the clutch slave cylinder mounted ...

...clutch master cylinder is mounted on the firewall under the hood ,it has its own reservoir with a screw top or a rubber cap on it,just remove the top & fill it there .....hope this ...

Question about 2003 ION

1 Answer

...in gear. How do I adjust clutch and where is it located under the hood? your clutch has had a fluid leak failure in the master or slave. someone has to determine which, replace and bleed the

Question about 2004 ION

1 Answer

...cylinder,a clutch slave cylinder,and the fluid.If you press on the clutch pedal and there is no pressure you lost the fluid,if either leak from the master or the slave even the hose line,A rule of ...

2003 saturn ion 2. i pressed my clutch in and not it wont reengage. it acts as if the trans shelled out but im pretty sure its not. would it be my slave sylinder Hello Jason, that could very well be ,

2003 Saturn ion 2, I pressed the clutch in and I won't reengage. It acts as if the trans shelled out but I know it hasnt , could it be the slave cylinder? This type of church uses fluid from the brake

.next day same thing pedal goes to floor and then gets pressure after pumped 12-15 times You have air getting into the clutch hydraulic system, this is due to a faulty slave or master cylinder or both

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...