Questions & Answers for: 2003 jeep grand cherokee idles

...jeep grand cherokee stalls check your transmission fluid,the motor will stall when fluid is low Replace the idle air control (I.A.C) motor on the throttle body chk and change complete throttle body ...

jeep grand cherokee limited 5.7 hemi vehicles hesitates engine light stays on. vehicle hesitates during take off and rough idle. has 64000 miles. pulled up code and says egr valve looking for location

2003 Jeep Grand Cherokee Runs Rough I have a 2003 jeep grand cherokee 4.0. At first when i would start it, it would idle really rough but after giving it a little gas it would stop. Now it runs rough ...

...Jeep Grand Cherokee special Edition 4.0. Idles very rough. I have changed plugs, all 4 O2 sensors.and gas filter regulator. Vehicle continues to idle rough. Vehilce show no codes. Vehicle runs great ...

...2003 Jeep laredo . check for vacuum leaks and make sure throtlebody plate is clean, use throtlebody cleaner and an old tooth brush to clean, if problem is still there then replace the valve (idle air ...

...2003 jeep grand cherokee 4.0L that I have replaced the radiator, thermostat, and temp. switch and my vehicle is still overheating when it is idling for more then 6 min. Do you have any suggestions? ...

...rough when idleing but fine when driving ok so it has a v8 have you tried the coil? for some reason on grand cherokees one side or the other seem to go out. i have ran into that a few times when i ...

...jeep grand cherokee special edition engine computer 4x4 jeep cherokee special edition. battery went dead and we just put in a new engine. how do i reset the engine computer? the engine starts but ...

...Jeep Gd cherokee Larado with 177K miles. Recently it will run and idle rough after shutting the engine off and starting again within a few minutes. I do delivers one day a week and do a lot of ...

2003 jeep grand cherokee with idle issues have had thousands of dollars in repairs and still idles rough, mostly when at a stop Throttle Position Sensor? Has that been replaced? Relatively inexpensive