...2002 Ford Explorer..The engine was knocking really bad. Changed the oil. it got a little quietter. Let it run for a few minutes then it stalled. Tried to restart it and it wont do anything but click ...
Question about 2002 Explorer
2002 explorer ping during acceleration until it shift to 3rd gear The engine has new plugs and I add injector cleaner. Why doesn't the anti-knock senor eliminate this?? the knock sensor senses knock ...
where is the knock sensor located on a Ford Explorer 2002 V6 SOHC? a knock sensor is always located on the engine block, usually in line with the first or last cylinder.
2002 Ford Explorer, driving uphill, cruise control on. All dashlights came on, engine died. Wont restart, sounds like knocking from valve cover, left side of engine when turned over now, once every ...
Question about 2002 Explorer
2002 ford explorer with 137,000 engine just yesterday began to knock. Oil is ok, How to diagnose an engine knocking sound. Oil is full, radiator is full. Engine has 137,000 miles. Does not burn oil. ...
...engine damage, could be a bearing or low oil pressure but if knocking the damage is done. i would have a tech just double check it to make sure, i have seen flywheels make noise and pulleys and a/c ...
Knock in oil pan when idling On first engine start of the day I can hear oil being picked up rattling. Goes away immediatly and can hear quiet knock in pan(i went under vehicle) no noise with ...
Question about 2002 Explorer
...ford exp XLT 2002 hear it in the morning when it is cold, started, diminished as it gets warm or operating normal temperature, it does it when I accelerate suddenly. Make sure the oil level is good. ...
Question about 2002 Explorer
...2002 ford explorer. Want to know what that could be and how much it would cost me to fix? If serious you will need a bearing replacement. Wild guess $500 to $1000. if done right. you may want to have ...
Question about 2002 Explorer
...2002 Ford explorer XLT 4.0 l v6 Hi there this sensor is normally situated on one or both sides of cylinder wall of a engine block, round shaped base with a 8 mm retainer bolt and a 2 or 3 pin ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions