Questions & Answers for: 2001 pontiac grand 3 head

...pontiac grand am 99 1st u must use all new head bolts, that said follow this factory procedure from the manual. HEAD BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE SEQUENCE --------- | 6 2 3 7 | | 5 1 ...

...additional 30 degrees. if you don't have the the torque sequence here it is 6 1 3 7 8 4 2 5 this is the head 11 1 3 10 8 5 7 6 12 4 2 9 this is the lower intake 11 Ft lbs (15Nm) hope this helps ...

...pontiac grand prix it has a 3100 motor. i would recomend double check but am almost positive because is been the same torque for many years for this engine and is 33 ft.lbs plus 90 degrees and the ...

...way out Torque to 44 ftlbs then an additonal 95 degrees start inside and work cross pattern out. I need the Torque spec's for a 2001 Pontiac grand am se 3.4L motor I need both Heads and Manifold ...

...Head Bolts Torque sequence --------- ' 6 2 3 7 ' ' 5 1 4 8 ' --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees recheck final torque in sequence *** CAUTION ...

...head bolt torque sequence-3.8L engine Install the new cylinder head gasket with the arrow pointing to the front of the engine. Install the cylinder head. Install NEW cylinder head bolts. Torque the ...

...uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque. ...

...grand am gt 3.4 head torque requires new head bolts. also requires thread sealant to be applied to bolts because they go into coolant passages. The torque spec is 60 n.m (44 lb ft) and then and ...

...grand am SO I will give you both the 4cyl and 6cyl Specs. Also you didn't ask for the torque sequence. I will include that as well for both. 2.3 DOHC Quad 4cyl: Torque sequence---> front ' 7 3 1 5 ...

...Pontiac Grand AM 3.4 head gasket bolts Says here https://www.2carpros.com/questions/sequence-to-tighten-head-bolts-and-rocker-arms-also-torque-specs ...